National Instruments cRIO-9034 Getting Started Manual page 7

1. LEDs
2. Ethernet Ports
3. Power Connector
4. SD LEDs
5. SD Card Removable Storage
6. Ground Screw
7. USER1 Button
Connecting the cRIO-9034 to Ground
You must connect the cRIO-9034 grounding terminal to the grounding electrode system of the
facility.
What to Use
• Ring lug
2
• Wire, 1.3 mm
• Screwdriver, Phillips #2
What to Do
Complete the following steps to ground the cRIO-9034.
1. Attach the ring lug to the wire.
2. Remove the grounding screw from the grounding terminal on the cRIO-9034.
3. Attach the ring lug to the grounding terminal.
4. Tighten the grounding screw to 0.5 N · m (4.4 lb · in.) of torque.
5. Attach the other end of the wire to the grounding electrode system of your facility using a
method that is appropriate for your application.
Figure 2. cRIO-9034 Front Panel
14
13
12
11
(16 AWG) or larger
1 2 3
10 9 8 7
8. RS-232 Serial Port
9. RS-485/422 (DTE) Serial Port
10. USB Host Ports
11. Mini DisplayPort
12. Cable Retention Mounts
13. USB Device Port
14. Power and Reset Buttons
NI cRIO-9034 Getting Started Guide | © National Instruments | 7
4
5
6