Table of Contents
Advertisement
Getting Started
1. Power on the transmitter.
2. Connect the battery.
3. Power on the ESC switch.
1
4
Binding
The included receiver and transmitter are bound at
the factory. It is not likely that you will need to re-bind
the receiver; however, you must re-bind when you desire
to operate this receiver using another Pro Boat 2.4GHz
transmitter.
Failsafe
In the unlikely event that the radio connection is lost
during use (possibly due to low transmitter batteries
or distance between the receiver and transmitter), the
receiver will hold the rudder at the last command with
no throttle.
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode.
When the transmitter is powered on, normal control is
resumed.
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of a
single specific transmitter. The included transmitter and
receiver are bound at the factory. If you need to rebind,
follow the instructions below.
1. Power off the transmitter and ESC (electronic speed
control).
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The RED LED on the ESC flashes.
4. Press the bind button (A) on the receiver.
The RED LED on the ESC flashes rapidly.
5. Power on the transmitter.
6. The RED LED on the ESC turns solid when
the radio system is bound.
Instruction Manual
4. Test the transmitter's control
of the decoy (out of water) as
shown.
2
4
5. Launch the decoy into the water and start driving.
If the decoy does not go straight, adjust the
steering trim dial on the transmitter.
3
5
A
NOTICE: Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in bind
mode within 400 feet. Doing so may result in unexpected
binding.
EN
7
Advertisement
Table of Contents
