Table of Contents
Advertisement
EN
Control Check
IMPORTANT: Perform a control check at the beginning of
each boating session, after repair, or after installation of new
batteries.
Ensure the receiver antenna is extended properly and all
batteries are fully charged.
1. Power ON the transmitter and the boat.
Do not install the boat canopy.
2. Place the boat securely on the boat stand.
NOTICE: Do not operate the motor longer than 20 seconds
without water-cooling circulation or damage may result.
3. Check steering and throttle on the transmitter.
Getting Started
1. Power on the transmitter.
2. Connect the two batteries to the EC5 ™
connectors on the ESC.
3. Power on the ESC switch. The ESC arming
tones will sound.
4. Test the transmitter's control of the boat
with the boat on the display stand.
When You Are Finished
1. Power off the ESC.
2. Power off the transmitter.
3. Disconnect and remove the battery from the boat.
Tip: Always remove the canopy before storage or moisture
may allow mold and mildew to grow in the boat.
4. Drain water from inside the hull using the drain plug.
5. Fully dry the inside and outside of the boat, including the
water cooling lines and jacket around the motor. Carefully
dry all battery, motor and receiver connectors by removing
one at a time and reinstalling.
6. Remove the hatch before storing your boat.
1
6
1
3
7. Repair any damage or wear to the boat.
8. Lubricate the flex shaft using Pro Boat ® Marine Grease
(DYNE4200 or DYNE4201).
9. Note the lessons learned from the trimming of your boat,
including water and wind conditions.
NOTICE: When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as a
car. Doing so can damage the boat.
NOTICE: Using a larger propeller, or one with more pitch
than the one included (on 6S [22.2v]), may damage the
electronics and battery packs.
2
2
4
2.4GHZ DIGITAL
RADIO SYSTEM
3
X2
Sonicwake™ Self-Righting Deep-V Brushless RTR
2.4GHZ DIGITAL
RADIO SYSTEM
X2
Hide quick links:
Advertisement
Table of Contents
