SHOWTEC Infinity iS-100 Manual page 29

Infinity iS-100
03) Loosen the service lid of the housing, by sliding it to the bottom.
04) Gently tilt the head so the small metal housing will slide out more easy.
05) Turn the gobo wheel, with the gobo you want to remove, to the upside.
06) Gently lift up the gobo holder
07) Very carefully take the gobo out of the gobo holder with a pair of pliers.
08) Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the
pinchcock a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.
09) Put the gobo holder back under the pressing snap and push it back.
10) Replace the maintenance caps and fasten all screws.
Glass Gobo Orientation
Coated glass gobos are inserted with the coating against the rim of the holder (away from the spring).
Textured gobos are inserted with the smooth side against the spring. This provides the best results when
combining rotating gobos.
Coated side
When an object is held up to the coated side
there is no space between the object and its
reflection. The back edge of the gobo cannot be
seen when looking through the coated side.
Ordercode: 41500
10º and then gently pull out the gobo from its position.
When an object is held up to the uncoated side
there is a space between the object and its
reflection. The back edge of the gobo can be
seen when looking through the uncoated side.
28
Uncoated side
Fig. 08
Fig. 09