Table of Contents
Advertisement
Gate "auto close" function works
like "auto open "
Gate doesn't stop immediately
when it reaches the end of travel.
Flashing light doesn't work.
1. The first operation should be defined as
gate closing during the learning mode
no matter what the method of
installation is.
2. If the gate executes the contrary action,
please swap the wiring of the motor to
the opposite polarity.
1. Adjust the VR1 to decrease the over
current limit.
Check the wiring of the flashing light to
make sure that it is well connected and
using the correct polarity.
Check that ~18V AC is present on the
output side of the transformer. Check that
~14VDC is present on the terminals of the
battery when the unit is plugged into AC
and that at least ~12V DC is present when it
is not plugged into AC but after charging.
29
Advertisement
Table of Contents
