Table of Contents
Advertisement
9. Using the RF Remote Control
Fig.8
WARNING: Notify the users that the gate is never to be operated unless it is in full view.
How to add an additional remote control
Please press button SW2, the L4 (LED for code learning) will be turned on and the receiver
module will be changed to the "RF Remote Learning Mode" for 30 seconds. During the "RF
Remote Learning Mode" period, press the main button one (black one on the left) of the
transmitter, it will then be memorized(up to 15 different transmitters can be memorized).
After the LED light is turned off, the receiver module will go back to the "normal mode" and
the system can be operated normally.
Up to 15 remote controls may be used. Additional RF Remote controls can be obtained
through your dealer. To find a dealer go to www.gatekeeperltd.com/dealers
How to erase remote controls
To erase existing remote controls, the memory can be cleared completely if the SW2 (code
learning) is pressed continuously for 10 seconds.
19
Advertisement
Table of Contents
