X-lite X-1005 Safety And Instructions For Use page 18

X-1005
1.3 Place the PINLOCK
The silicone-sealed profile of the PINLOCK
the inner surface of the visor.
1.4 Insert one side of the PINLOCK
it in position (Fig.8).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.9).
1.6 Release the visor.
1.7 Peel the protective film off the PINLOCK
cone-sealed profile adheres to the whole visor.
1.8 Fit the visor on the helmet (see instructions above).
2 CHECKING AND ADJUSTING THE STRETCH
Check that the PINLOCK
the visor and ensuring that they do not move with respect to each other.
If the PINLOCK inner visor is not tightly fixed to the visor, simultaneously move both
®
external adjustment levers upwards to increase the stretch (Fig.7). This operation must
be carried out gradually. The maximum stretch is achieved when the pin adjustment
external levers are turned outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, use in particular weather conditions (low tempera-
tures, high humidity, sudden changes in temperature or heavy rain) or intense and
prolonged use may affect the performance of the PINLOCK
fogging or formation of condensation. In such cases, to restore the system effi-
ciency after using the helmet, remove the PINLOCK
visor and leave it to dry in warm and dry air. The same procedure must be applied
to the helmet, which should be left to dry to remove any humidity that may have
formed as a result of the conditions described above.
3 DISASSEMBLING THE PINLOCK
3.1 DISASSEMBLE THE VISOR EQUIPPED WITH the PINLOCK
structions above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
18
INSTRUCTIONS FOR USE
inner visor on the visor.
®
inner visor onto one of the two visor pins and hold
®
inner visor has been correctly fitted by opening and closing
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly fitted and stretched.
®
INNER VISOR
®
inner visor must be in contact with
®
inner visor to the other
®
inner visor and check that its sili-
®
inner visor to prevent it from
®
inner visor may result in exces-
®
®
inner visor from the helmet
®
inner visor from the pins (Fig.9).
®
inner visor and cause
inner visor (see in-
®