X-lite X-1005 Safety And Instructions For Use page 17

VISOR (XMS-02)
1 DISASSEMBLY
1.1 Close the chin guard (if open) and open the visor completely.
1.2 Push the release lever of the left side mechanism completely downwards (Fig.5)
and simultaneously push the visor away from the helmet initially projecting the
lower hook "A" and then the top hook "B" from the corresponding seats in the side
mechanism (Fig.6).
1.3 Follow the previous operations on the right side of the helmet.
2 ASSEMBLY
2.1 Close the chin guard (if open) and position the left side of the visor on the cor-
responding side mechanism by inserting the top hook "B" of the visor into the
corresponding seat therein. Align the lower hook "A" of the visor above the corre-
sponding seat in the same mechanism (Fig.6).
2.2 Press the visor at the lower hook "A" so that the release lever recedes and then re-
turns to position, hooking the visor to the side mechanism with just a click (Fig.5).
2.3 Follow the previous operations on the right side of the helmet.
2.4 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open the visor. By lifting the
chin guard, the visor closes automatically. If necessary, repeat the same opera-
tions mentioned above.
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure the latter is held in place in its different positions by the mechanisms
itself. If necessary, repeat the same operations mentioned above.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the chin guard.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
MINIMUM OPENING POSITION WITH DEFOGGING FUNCTION
The visor can be slightly opened, with no need to place it on the first notch of the mech-
anism. In this configuration, the inner central pawl of the visor leans onto a specific
seat on the helmet chin guard that allows the visor to be kept in a minimum opening
position for a better ventilation and making defogging easier, especially at low speed
or during short stops.
(Available as standard or accessory/spare part)
1 ASSEMBLY
1.1 Disassemble the visor (see instructions above).
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.7).
INSTRUCTIONS FOR USE
X-1005
17