Table of Contents
Advertisement
XR1045
Optional Controls and Indicators
Two Wheel Rear (2WR) Steering Switch
A Two Wheel Rear (2WR) Steering switch is used to engage
and disengage the optional rear wheel steering feature
Figure 6-40. Two Wheel Rear (2WR) Steering Switch.
Warning
DO NOT change steering modes until the forklift slows
or comes to a complete stop. Align all four (4) wheels
perpendicular to the axle, before changing steering
mode. Changing steering modes at higher travel
speeds can make the forklift unstable, and cause a loss
of control, which could result in death, serious injury,
or property damage.
Boom Angle Indicator
The boom angle indicator is located on the left side of
the boom and is visible from the operator's seat Use
the boom angle indicator to determine the boom angle
when referring to load capacity charts Refer to the
Load Capacity Charts section of this manual for more
information
NOTE: The boom angle indicator is a plumb arrow with
angular graduations from -5 to +70°
Figure 6-41. Boom Angle Indicator.
For information call (800) 497-1704
Boom Extend Letters
As the boom is extended, boom extend letters appear on
the left side of the boom visible to the operator These
letters indicate boom extension as it corresponds to the
load capacity charts
Figure 6-42. Boom Extend Letters.
Frame Level Indicator
The frame level indicator is mounted on the upper right
corner of the operator's cab The frame level indicator
allows the operator to view if the forklift has been
positioned in a level condition Always frame sway the
forklift right or left until the indicator shows 0° (level)
Figure 6-43. Frame Level Indicator.
Operator Cab
Page 45
Advertisement
Table of Contents
