Table of Contents
Advertisement
Operator Cab
Lumbar Support
The seat controls include a 4 position lumbar support
knob Rotate the lumbar support knob to raise, lower,
increase, or decrease the lumbar support
Figure 6-10. Lumbar Support.
Fore and Aft Adjustment Lever
Pull the fore and aft adjustment lever outward from the
seat to release the seat lock Slide the seat forward or
backward to a comfortable location and release the lever
to lock the seat in the desired position
Figure 6-11. Fore and Aft Adjustment Lever.
Page 36
Backrest Angle Adjustment Lever
Pull the backrest angle adjustment lever up to release the
seat backrest lock Adjust the angle of the backrest and
release the lever to lock the backrest to the desired angle
Figure 6-12. Backrest Angle Adjustment Lever.
Seat Belt
Warning
Always check the condition of the seat belt
and mounting hardware before operating
the forklift. If the seat belt or mounting
hardware is defective, it may not properly
restrain the operator, which could result in death or
serious injury.
• DO NOT operate the forklift until the seat belt or
mounting hardware is replaced, if worn or damaged.
• The seat belt MUST be worn while operating the
forklift. Failure to wear the seat belt could result in
death or serious injury.
The reach forklift is equipped with a standard two inch
(2") wide retractable seat belt A three inch (3") wide
retractable seat belt is available where required by state
and local laws and regulations
Figure 6-13. Retractable Seat Belt.
XR1045
Xtreme Manufacturing, LLC
Advertisement
Table of Contents
