Frame Leveling - Xtreme XR1045 Operation & Safety Manual

Operation
Preparation and Set-Up:
1) DO NOT alter or modify the work platform in any
manner that is detrimental to its safe use
2) Make sure that the work platform is securely attached
to the quick attach or forks Follow the platform
manufacturer's instructions
3) Make sure the platform, carriage and forks are secured
to prevent them from pivoting from side to side
4) On side tilt or swing carriage, the carriage must be
centered and/or leveled horizontally and vertically
The hydraulic system quick disconnects must also be
disconnected and the carriage securely fastened to
prevent any tilting or side to side swinging motion
5) Ensure the vehicle has a firm footing and is level
6) Be sure the vehicle is in a level position (side to side)
before any operation is begun Use the frame sway
to level the vehicle If the vehicle cannot be leveled,
reposition the vehicle
7) Place the travel select lever in the NEUTRAL position
8) Engage the parking brake switch Blocking the wheels
is also recommended
9) Level the platform in both the side-to-side and front-
to-back directions before use
10) Before lifting or lowering personnel, be sure the
vehicle lifting mechanism operates smoothly through the
entire lifting and lowering of the platform and maintains
its self leveling function The vehicle must operate
smoothly both empty and loaded
11) Lift and lower personnel smoothly, with caution, and
only at their request
12) Keep hands and feet clear of controls other than
those in use
13) Be certain that the path of platform travel is clear
of hazards, e g , storage racks, scaffolds, overhead
obstructions, and electrical wires
14) Be sure any lift limiting devices and latches are
functioning properly
15) A trained operator shall be in position to control the
rough terrain forklift truck When the operator is not in
the operating position, block the truck wheels and apply
the parking brake with all controls in neutral
16) Alert elevated personnel before moving the platform
Then move the platform smoothly and with caution
17) Always lower the platform if you must move the
rough terrain forklift truck for adjustment in positioning
18) Be certain that personnel and equipment on the
platform do not exceed the available space
19) Any body belt, lanyard or deceleration devices which
Page 66
has sustained permanent deformation or is otherwise
damaged shall be replaced
20) Use of railings, planks, ladders, etc on the platform
for purpose of achieving additional reach or height is
prohibited
21) Before elevating personnel, the area around and
under the work platform should be marked to warn
anyone on the ground that overhead work is being done
22) The platform shall be lowered to ground level for
personnel to enter and exit Personnel shall not climb on
any part of the rough terrain forklift in attempting to enter
and exit
23) Protection must be provided for the personnel on the
work platform from pinch points or moving parts while in
their normal working position on the platform
24) Provide overhead protection device as required by
work site conditions or if requested by the user of the
platform

Frame Leveling

 Warning
Use of the frame sway control with the
boom raised above horizontal could cause
tip over, which could result in death or
serious injury. Always use the frame sway
control to level the forklift BEFORE raising the boom
above horizontal. If the forklift cannot be leveled
using the frame sway control, do not attempt to raise
or place load. Reposition forklift or have surface
leveled.
The frame sway control handle has variable motions from
the center that control frame sway (right and left)
Table 11. Frame Sway Functions
Function Control Handle Action
FRAME SWAY RIGHT Move control handle RIGHT
FRAME SWAY LEFT Move control handle LEFT
Figure 7-34. Frame Sway Control Handle.
XR1045
Xtreme Manufacturing, LLC