Arris Touchstone TM402 Installation Manual page 23

Procedure 2-3 (continued)
Mounting the Telephony Modem
Wall-mounting instructions
3
4
5
6
7
Desktop mounting instructions
8
9
Position the mounting template on the surface where you intend to mount the
Telephony Modem and secure in place with transparent tape.
Drill holes through the template in the specified locations for the mounting
screws. After drilling holes, remove the template from the surface.
If using drywall anchors, set them into the wall. Then drive the screws leaving
a gap of about 3 mm (0.12 inches) between the screw head and the wall.
Lift the Telephony Modem into position. Slip the large end of the mounting
slots (in the back of the Telephony Modem) over the screws, then slide the
vertically or horizontally until the narrow end of the keyhole slot contacts the
screw shaft.
Proceed to "Connecting the Telephony Modem" on page 2-11.
Ensure that sufficient room is available where you plan to place the
Telephony Modem to allow for proper ventilation.
Orient the Telephony Modem so that the RF, power and computer
connections are within reach of the cables. Place the Telephony Modem
where there is no danger of it falling to the floor.
—continued—
Telephony Modem Installation Guide Release 4 Standard 3.0 Aug 2004
Installing the Telephony Modem 2-9