Changing A Program; Cancelling A Program; Switching The Machine Off; Maintenance And Cleaning - Westinghouse WSF6608X User Manual

Changing a program

If you would like to change programs
while a washing program is on .
After the program stops, select
the desired program pressing the
PROGRAM button

Cancelling a program

If you would like to cancel a program while
a washing program is in progress .

Switching the machine off

When the END light comes on, switch your
1
machine off by using the POWER button
TIPS AND INFORMATION TIPS & INFORMATION
NOTE: If the machine door is opened during washing or
the power is cut off, the machine resumes the program
when the door is shut or the power comes back.
NOTE: For better drying results, when the program has
finished keep the door ajar for some minutes before you
remove the dishes.
20
SWITCHING ON THE MACHINE AND SELECTING A PROGRAM
Press the PAUSE/START button 1
2
Press the PAUSE/START
3
button to start the
selected new program
Press and hold the START/
1
PAUSE button for approx . 3
seconds until END light blinks
After END light starts blinking, the water inside 2
is discharged for approx . 30 seconds
Once END light comes on, it means that the
cycle has been cancelled
2 Pull the plug out of the outlet . Turn off the water tap

MAINTENANCE AND CLEANING

Swtich off the power supply or disconnect the product
before any maintenance or cleaning operation .
Cleaning the machine at regular intervals prolongs
the machine's service life .
Oil and lime may accumulate in the machine's washing
section . To clean the machine:
Fill the detergent compartment with detergent, do not
load any dishes into the machine, select a program
that runs at high temperature, and start the machine .
Alternatively, use descaling material available in the
market . (Dishwasher cleaners produced by detergent
manufacturers .)
Cleaning the seals in the machine door
To clean any accumulated residues in the door seals,
wipe the seals regularly by using a dampened cloth .
Cleaning the machine
Clean the filters and spray arms at least once a week .
Unplug your machine and turn off its tap before
starting the cleaning . Do not use abrasive materials
when cleaning your machine . Wipe with a fine cleaning
material and a dampened cloth .

Filters

Check if any food wastes have remained on the
coarse and fine filters . If any food wastes is found,
remove the filters and clean them thoroughly with water
under the tap .
a . Micro Filter
b . Coarse Filter
c . Metal
1 To remove and clean the filter combination (a+b),
turn it counter clockwise and remove it by lifting
upwards .
2 Pull and remove the metal filter (c) .
3 Then pull the coarse filter (b) out of the micro filter .
Rinse it with water under the tap and reassemble .
4 Relocate the Coarse/Micro filter (a) combination
into the metal filter and turn it in the direction of
the arrow It is locked when the arrows on the micro
filter can be seen on either side .
5 Reposition the metal filter in the machine .
6 Never use your dishwasher without any filter .
7 Incorrect fitting of the filter will reduce the washing
effectiveness .
8 Clean filters are very important in terms of the
proper running of the machine .
1
3
b
a
SWITCHING ON THE MACHINE AND SELECTING A PROGRAM
2
c
4
SWITCHING ON
21