6
Maintenance and cleaning
6.1
Batteries (no rechargeable batteries)
When the
icon flashes, the batteries must be replaced. To do this, unscrew the cover at
the back and remove the old batteries. Replace them with 2 new CR2016 button cells.
6.2
Troubleshooting
Problem
Meter does not switch on
No measured value is
displayed
The measured value is
inaccurate
6.3
Maintenance of the impact body
No special maintenance is required, apart from occasional (after approx. 1000 ... 2000
measurements) cleaning of the impact body and the guide tube. To do this, unscrew the support
ring and remove the impact body. The impact body must be cleaned of dirt and metal dust. Clean
the guide tube with the brush provided. Do not put oil or grease on the impact body. The impact
body must be loosened after each use.
The impact body is excluded from the warranty!
Cause
Batteries flat
No measurement
Calibration expired
© PCE Instruments
14
Solution
Replace the batteries.
Check
the
release
course of the impact body. If
it hits the test spot without
any problems, contact our
service department.
Calibrate the meter.
and