Table of Contents
Advertisement
10. FIRMWARE UPDATE
The process to update firmware varies slightly between the 2 models; however the Main firmeware file type loaded
is the same.
Instructions for updating Firmware on a matrix are detailed on the Firmware Update Page for that product.
Before beginning the Firmware Update process download and unzip the latest firmware update from the
B-120-HDMATRIX product page for the matrix to be updated and store in a location you will remember on your
PC. Be sure the firmware file from the downloaded folder is not compressed or in a compressed folder before
updating.
IMPORTANT: A hardware RS-232 serial port on a laptop or desktop PC may be more reliable for updating
firmware than a USB to RS-232 Adapter. If you have trouble updating using an adapter, please use a PC with a
built-in RS-232 port.
11. NETWORK CONFIGURATION
Displays and sets the Network IP address for all B-120-HDMATRIX-Matrix switchers.
NOTE: Only Static IP address mode is available – DHCP is not supported.
NOTE: The default IP Address for the matrix is 192.168.0.99. The IP Address and Subnet Mask are not reset
during FIRMWARE UPDATE or RESET FACTORY DEFAULTS operations.
When NETWORK CONFIGURATION is selected, the following window is shown. If you want to know what the
current IP address and Subnet Mask are. press the READ FROM DEVICE button. If you have not reset, the IP
Address in the matrix iwill be 192.168.0.99 as shown below.
To change the values, enter the desired IP Address and Subnet Mask, and then press WRITE TO DEVICE. After
changing the values, confirm the update worked correctly by clicking READ FROM DEVICE again.
After changing the network configuration, the matrix should be turned off and on again in order to use the new
settings.
12. RESETTING FACTORY DEFAULTS
FIGURE 5
11
Advertisement
Table of Contents
