Edid Status; Advanced Configuration; Pc Configuration Other Settings; Ir Receiver Active - Binary B-100-HDMATRIX-4X4 Owner's Manual

4.3 EDID Status

Once EDIDs are configured, the assigned EDID for sources can be reviewed to ensure that
the desired output is configured or for troubleshooting.
Example: Input=3
1. Press STATUS
2. Press INPUT
3. Press Number Key (1-8)to select the desired Input
4. Press ENTER
• If the second digit (the Input being queried) has a dot after it, then the first digit is
the EDID number from the Embedded EDID table.
• If the second digit (the Input being queried) does not have a dot after it, then the
first digit is the Output the EDID was learned from.

5 Advanced Configuration

During the installation of an HDMatrix, there are settings that provide Advanced Configuration above
the use of the remote. These allow for fine tuning the HDMatrix when used under certain conditions
and the settings listed below are not available from the remote.
For more information refer to the Configuration Utility manual available on the SnapAV website
5.1

PC Configuration Other Settings

The following settings can be found in the PC Configuration Utility Other Settings menu.
5.1.1

IR Receiver Active

Use this setting to disable the front panel IR receiver to avoid IR command conflicts and prevent IR
flooding of the HDMatrix. When IR is disabled, RS232 or IP must be used to control the HDMatrix.
5.1.2

Front Panel Power Button Active

Use this feature to disable/Enable the front panel power button of the HDMatrix when using an
Automation System. This will prevent the HDMatrix from being powered OFF and preventing control
of the device from an automation system UI.
5.1.3

HDMI Input EQ Setting

Use these settings when an HDMI image contains video noise and artifacts that can occur during
switching or viewing some HDMI sources or displays. Each input can be set to High when video noise
is present. We recommend that this be set to LOW as a starting point, and only changed should video
noise be present on a particular input.
© 2011 Binary
B-100 HDMATRIX Installation and Users Manual 4X4 & 8X8
Display Readout (Example)
EDID 5 Assigned
from Embedded
EDID Table
--
--
-3
5 3
. .
EDID Learned
from Output 4
--
--
-3
4 3
.
pg.15