Use Instructions - Vestil JIB-HC-Series Instruction Manual

Use instructions:

Before using the crane for the first time, OSHA regulations require an "Initial Inspection". The inspection procedure is
paraphrased on p. 11-12. However, you should read the entire regulation periodically, which can be accessed through
http://www.OSHA.gov/.
To reduce the likelihood of serious personal injuries caused by improper or careless operation:
 Only qualified, designated crane operators should use this device. The operating instructions in this manual
supplement safe crane and hoist operation practices learned during your training program. ALWAYS apply the safe
material handling practices learned from your training program (for example, practical operating examination) and
conform to OSHA crane operation standards (29 CFR 1910.179).
 All personnel not using the crane should remain outside the operating area during use. Instruct all persons to
remain at a safe distance during operation.
 DO NOT use the crane if: 1) you observe any damage to the (wall mounting) brackets or hear unusual noise during
use; 2) if you observe any warping or deformation of the boom, the brackets, the load hook or chain (or cable). Notify
your supervisor and authorized maintenance personnel if you notice anything unusual.
Proper load lifting:
Always follow the instructions provided with your hoist and trolley.
Position the trolley and hoist directly above the load. Proper loading requires the operator to position the hoist
above the center of the load. Proper positioning is diagrammed below:
Proper load centering beneath hoist and trolley
Side view
Improperly positioned loads
Side view
Connect the load to the hoist chain/cable, using appropriate rigging. Then, raise the load only as high as
necessary. Slowly direct the load to the desired location. Once the I-beam and hoist are properly centered above the
work location, lower the load and disconnect it from the hoist.
Copyright 2016 Vestil Manufacturing Co.
Rev. 10/17/2016
Hoist cable/chain aligned with centerline (red dashed line)
Hoist cable/chain not aligned with centerline (red dashed line)
JIB-HC, MANUAL
Front view
Front view
Page 7 of 10