Vestil P-JIB Series Instruction Manual

Vestil P-JIB Series Instruction Manual

Portable jib crane

Advertisement

Quick Links

Receiving instructions:
After delivery, remove the packaging from the product. Inspect the product closely to determine whether it sustained damage
during transport. If damage is discovered, immediately record a complete description of the damage on the bill of lading. If the
product is undamaged, discard the packaging.
Note:
The end-user is solely responsible for confirming that product design, installation, use, and maintenance comply with laws,
regulations, codes, and mandatory standards applied where the product is used.
Signal words................................................................................................................................................. 2
Safe use recommendations............................................................................................................................. 2
FIG. 1A: P-JIB-2 exploded parts diagram & bill of materials.................................................................................... 3
FIG. 1B: P-JIB-2 specifications......................................................................................................................... 4
FIG. 2A: P-JIB-4 exploded parts diagram & bill of materials.................................................................................... 5
FIG. 2B: P-JIB-4 specifications.............................................................................................................................. 6
FIG. 3: Manual hydraulic pump exploded parts diagram & bill of materials................................................................. 7
Operating the crane....................................................................................................................... ................ 8
Operating the hand pump................................................................................................................................ 8
Air bleeding procedure........................................................................................ .......................................... 9
Boom length adjustment................................................................................................................................. 9
Inspections & Maintenance.............................................................................................................................. 9 - 10
Labeling diagram......................................................................................................................................... 10
Limited Warranty.......................................................................................................................................... 11
Copyright 2017 Vestil Manufacturing Co.
Rev. 3/14/2017
Vestil Manufacturing Corp.
2999 North Wayne Street, P.O. Box 507, Angola, IN 46703
Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868
www.vestilmfg.com
P-JIB Portable Jib Crane
Instruction Manual

Table of Contents

Fax: (260) 665-1339
e-mail:
sales@vestil.com
Page 1 of 11
P-JIB, MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P-JIB Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vestil P-JIB Series

  • Page 1: Table Of Contents

    Operating the crane…………………………………..…………………………………………………………………… ……………. 8 Operating the hand pump………………..…………………………………………………………………….……………………….. 8 Air bleeding procedure……………………………………………………………………………. …………………………………… 9 Boom length adjustment………………………………………………………………………………………………………………… 9 Inspections & Maintenance……………………………..…………………………………………........... 9 - 10 Labeling diagram……...……………………………….………………………………………………………………………………. 10 Limited Warranty…...…………………………………………………………………………………………………………………… 11 Copyright 2017 Vestil Manufacturing Co. Page 1 of 11...
  • Page 2: Signal Words

     Follow the inspection and maintenance procedures provided on pp. 9-10. If repairs are necessary, only install manufacturer-approved replacement parts.  Periodically lubricate pivot points.  Keep the crane clean & dry. Copyright 2017 Vestil Manufacturing Co. Page 2 of 11...
  • Page 3 #11 hitch pin clip, ”x2 ” 08-145-010 Shackle, ”, 2-ton capacity 65127 Cotter pin, zinc-plated, ”-2 47-112-001 Clevis pin, 1” x 3 ” 30-001-011 Leveling jack 99-027-003 ” cable pulley, 3” OD, ” ID Copyright 2017 Vestil Manufacturing Co. Page 3 of 11...
  • Page 4 The inner boom has 4 pin holes spaced 7 inches apart to allow boom length to be adjusted. Boom length determines the maximum rated load of the crane, which decreases as boom length increases as indicated in the table below. Copyright 2017 Vestil Manufacturing Co. Page 4 of 11...
  • Page 5 ”-20 x 1 ” 08-145-010 Shackle, ”, 2-ton capacity Nylon lock nut, grade 2, zinc-finish, ” - 37018 47-112-001 Clevis pin, 1”x3 ” 28-612-005 Weldment, outrigger pin 99-027-003 Cable pulley, ”, 3”OD, ”ID Copyright 2017 Vestil Manufacturing Co. Page 5 of 11...
  • Page 6 The inner boom has 4 pin holes spaced 7 inches apart to allow boom length to be adjusted. Boom length determines the maximum rated load of the crane, which decreases as boom length increases as indicated in the table below. Copyright 2017 Vestil Manufacturing Co. Page 6 of 11...
  • Page 7 Seal, square profile, release 99-144-015 Seal, U-cup 99-039-003- 99-117-008 Retainer, seal Pump, manual, hand pump ASME 94198 FHSCS utility grade, 10-24 x B18.8.2- 0.3127x2.5 99-025-023 Handle, release Clevis pin 99-144-001 Replacement seals (kit) Copyright 2017 Vestil Manufacturing Co. Page 7 of 11...
  • Page 8: Operating The Crane

    To change load elevation but not lower the load completely, simply close the release valve when the load is at the desired height, i.e. turn the lever clockwise until the connection is snug. Copyright 2017 Vestil Manufacturing Co. Page 8 of 11...
  • Page 9: Air Bleeding Procedure

    The opening in the lifting arm for the shackle should not be stretched, bent or cracked. 5.) Inner and outer booms: confirm that both parts are rigid and square. 6.) Make a dated record of the repairs, adjustments and replacements made. Copyright 2017 Vestil Manufacturing Co. Page 9 of 11...
  • Page 10: Labeling Diagram

    E: Label 287 (on counterweight; model, F: Use instructions G: Floor lock info. serial number, & capacity) LOCATE OUTRIGGERS AND Model: LJ-17 ENGAGE LEVELING JACKS LEVELING JACK. 17” TRAVEL BEFORE LIFTING LOAD. Made in China Copyright 2017 Vestil Manufacturing Co. Page 10 of 11...
  • Page 11: Limited Warranty

    (you) for warranty service. Who may request service? Only a warrantee may request service. You are a warrantee if you purchased the product from Vestil or from an authorized distributor AND Vestil has been fully paid.

This manual is also suitable for:

P-jib-2P-jib-4

Table of Contents