Installing A Psu Blank - Cisco UCS X9508 Installation Manual

Installing and Removing Components
What to do next
Choose the appropriate option:
• If you are installing a PSU, go to
• If you are installing a PSU blank, go to

Installing a PSU Blank

The minimum supported power configuration for the UCS X9508 server chassis is three PSUs. If you will be
operating the server chassis with an empty PSU bay, it must be covered with a PSU blank
(UCSX-9508-PSUBK).
Use this procedure to install a PSU blank.
Step 1
Grasp the PSU blank by the vertical finger hold on the right side of the blank's face.
Step 2 Align the PSU blank so that the word UP is facing up, and the handle is parallel to the right side of the PSU bay.
Step 3
Insert the PSU blank until its faceplate is flush with the front of the server chassis.
Figure 39: Inserting a PSU Blank
Installing a Power Supply, on page
Installing a PSU Blank, on page
Cisco UCS X9508 Server Chassis Installation Guide
Installing a PSU Blank
70.
75.
75