Removing A Fan For A Ucs Intelligent Fabric Module (Ifm) Or X-Fabric Module (Xfm) Blank - Cisco UCS X9508 Installation Manual

Installing and Removing Components
Removing a Fan for a UCS Intelligent Fabric Module (IFM) or X-Fabric Module
(XFM) Blank
Use the following procedure for removing a fan for a UCS Intelligent Fabric Module (IFM) or X-Fabric
Module (XFM) Blank.
Step 1
Grasp the fan by the tabs on each long side wall.
Step 2 Pull the fan straight up.
This step disconnects the fan from the power connector and lifts the fan off of the board.
Figure 45: Removing the Fan from a UCS X9508 Module or Module Blank
What to do next
Insert a fan module. Go to
(XFM) Blank, on page

Removing a Fan for a UCS Intelligent Fabric Module (IFM) or X-Fabric Module (XFM) Blank

Installing a Fan for a UCS Intelligent Fabric Module (IFM) or X-Fabric Module
88.
Cisco UCS X9508 Server Chassis Installation Guide
89