Table of Contents
Advertisement
Attachments Installation and Adjustment
5.13 Attachments Installation
and Adjustment
Several attachments aside from the frequently used
attachment/fork combination are available for use with
the telehandler. Installation and operation of other
approved attachments are covered in this section.
5.13-1 Installing Attachments Using the
Quick Attach Feature
1. Fasten the tethered pin assemblies to the apron
using the pins, washers, and cotter pins. See
Figure
47.
2. Ensure the apron is in the tilted forward position
with the quick attach pins hanging from the
tether.
3. Position the attachment on level ground.
4. Locate the boom so that the apron upper bar
can be raised and tilted backwards to engage
the attachment and lift it clear of the ground.
Cotter Pin
SJ1044 TH, SJ1044 THS, SJ1056 TH, SJ1056 THS,SJ1256 THS
5. Engage the attachment as described in step 4,
aligning the holes in the attachment for the
installation of the quick attach pins at a working
height.
6. Install the quick attach pins and secure them
with lynch pins to the outside of the attachment.
5.13-2 Removing Attachments Using the
1. Position the boom so the attachment is just
above level ground.
2. Shut down engine.
3. Move the quick attach pins and lynch pins from
the apron and attachment and leave them in a
hanging position.
4. Start engine.
5. Lower boom and tilt the apron forward (while
retracting the boom) to clear the attachment.
WARNING
Visually check the attachment is correctly coupled
and secured to the boom before operating the
telehandler.
Figure 47 Quick Attach Feature
Quick Attach Feature
Pin
Lynch Pin
Quick Attach
Pin
Section 5 – Operation
229076ABA
67
Advertisement
Table of Contents
