Table of Contents
Advertisement
INNERSHIELD PRO & MAGNUM CLASSIC GUN
K466-5 Installation
(For L-Tec feeders equipped with an L-Tec feeder
connector assembly, MIG 35, MIG 31A, 225...)
1. Remove brass cable connector (see Figure A.2) from the K466-5
kit and screw it onto the feeder end of the gun cable. Tighten the
connection with the wrench provided.
2. For L-Tec machines that require trigger lead connections to be
made at a terminal strip located within the machine (L-Tec 225),
a gun control cable with forked terminals is provided. Connect
the terminated leads to the terminal strip. For a machine that
requires a twist-lock gun control cable connection, continue to
use the L-Tec gun control cable provided with the
L-Tec wire feeder connector assembly. Connect the twist-lock
plug to the proper receptacle on the machine.
K466-6, K466-7, and K466-9 Installation
(Wirematic, Hobart Series 2000 Feeders, SP100T
Type and Power MIG)
1. Remove brass cable connector (see Figure A.2) from the connector
kit and screw it onto the feeder end of the gun cable. Tighten
the connection with the wrench provided.
2. Attach the gun control cable provided to the trigger connector on
the wire feeder.
INSULATION TUBE
(K466-1 ONLY)
BRASS CABLE
CONNECTOR
SET SCREW
LINER ASSEMBLY (LINER BUSHING TO BE SEATED
TIGHT AGAINST BRASS CABLE CONNECTOR
FEEDER END
CABLE HANDLE
MOLDED GAS
CABLE
PLUG
K613-2, K613-7 Installation
(Tweco #5 compatible feeders)
1. Remove brass cable connector from the kit and screw it onto the
feeder end of the gun cable. Tighten the connection with the
wrench provided.
2. For K613-7, attach the round connector of the gun control cable
provided to the trigger connector on the front of the Lincoln
feeder.
K613-6 Installation
(Lincoln Feeders, 3/32" diameter wire)
1. Remove brass cable connector and insulation tube from the kit.
Slide the insulation tube onto the connector from the threaded
end and screw it onto the feeder end of the gun cable. Tighten
the connection with the wrench provided.
2. Attach the round connector of the gun control cable provided to
the trigger connector on the front of the Lincoln Feeder.
FIGURE A.2
GUN HANDLE
TIP HOLDER
INSTALLATION
SHIELD CLAMPING SCREWS
GUN TUBE
INSULATOR
A-5
TIP
Advertisement
Table of Contents
