Connection To Feeder With Ready To Weld Gun; Conversion Of K126-10, K126-11, K126-12 Or K126-13 To Weld With Other Wire Feeders - Lincoln Electric Magnum K115-1 Operator's Manual

INNERSHIELD PRO & MAGNUM CLASSIC GUN
Read this entire installation section before you
start installation.
WARNING
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts
such as output terminals or internal
wiring.
• Insulate yourself from the work and ground.
• Always wear dry insulating gloves.
ConneCtion to Feeder with ready to weld
gun
Connecting a K126-10 or K126-11 to a Lincoln Feeder (5/64" or
smaller diameter wire).
The K126-10 or K126-11 will connect to any wire feeder with a
Lincoln style gun receiver bushing (i.e. LN-8, LN-9, LN-25 or any
feeder with a K1500-1 bushing installed). (See Figure A.1)
1. Check that the drive roll(s) and feeder guide tubes are
appropriate for the electrode size being used.
2. Fully push the brass connector end of the gun cable into the
conductor block on the outgoing side of the feeder wire drive.
Secure the cable using the hand screw or set screw in the
conductor block.
3. Insert the round connector of the control cable into the mating
FIGURE A.1
connector on the front of the wire feeder.
Connection to Adapted Feeders, Lincoln DH-10,
LN-10, STT-10, and Power Feed 10 wire feeders
(5/64" or smaller diameter wire).
The K126-12 gun and cable assembly will connect easily to any
properly adapted feeder.
1. Check that the adapter and feeder outgoing guide, as well as the
drive roll, are appropriate for the electrode size being used. On
Lincoln feeders, check that the K1500-2 gun adapter is in place.
2. Fully push the brass connector end of the gun cable into the
brass adapter on the outgoing side of the feeder wire drive.
Secure the cable using the hand screw or set screw in the
adapter.
3. Insert the round connector of the control cable into the mating
connector on the front of the wire feeder.
ConVersion oF K126-10, K126-11, K126-12 or
K126-13 to weld with other wire Feeders
Prepare gun and determine correct connector kit
1. Determine which K466 or K613 kit is required for your system
using (Tables A.1 and A.2) in the front part of the Installation
Section.
2. Remove the insulator, tip holder and gun control cable.
3. Lay gun and cable out straight on a flat surface.
4. Loosen set screw located in the brass cable connector at the
wire feeder end of the cable using the 5/64 (2.0 mm) Allen
wrench. Pull liner out of cable.
5. Remove the brass cable connector from the feeder end of the
gun using the wrench provided.
6. Install the new connector kit using the appropriate procedure
which follows.
K466-3/K613-3 Installation
(For Miller feeders)
1. Remove brass cable connector (see Figure A.2) from the kit and
screw it on to the feeder end of the gun cable. Tighten the
connection with the wrench provided.
2. Attach the round connector of the gun control cable provided to
the trigger connector on the front of the Miller feeder.
K466-4 Installation
(For Hobart feeders; i.e. 27...)
1. Remove brass cable connector (see Figure A.2) from the K466-4
kit and screw it on to the feeder end of the gun cable. Tighten
the connector with the wrench provided.
2. Attach the phone plug connector of the gun control cable
provided to the trigger connector on the front of the Hobart
feeder.
A-4
INSTALLATION