Chapter 4 - Antenna Information; Notice Regarding Compliance With Fcc, Eu, And Industry Canada Requirements For Rf Exposure; Antenna System Cellular Devices; Cellular And Lte Antenna - Multitech MultiConnect microCell User Manual

Hide thumbs Also See for MultiConnect microCell:

Table of Contents

Chapter 4 – Antenna Information

Notice regarding Compliance with FCC, EU, and Industry Canada

Requirements for RF Exposure

The antenna intended for use with this unit meets the requirements for mobile operating configurations and for

fixed mounted operations, as defined in 2.1091 of the FCC rules for satisfying RF exposure compliance. This device

also meets the European RF exposure requirements of EN 62311. If an alternate antenna is used, consult user

documentation for required antenna specifications.

Compliance of the device with the FCC, EU and IC rules regarding RF Exposure was established and is given with

the maximum antenna gain as specified above for a minimum distance of 20 cm between the devices radiating

structures (the antenna) and the body of users. Qualification for distances closer than 20 cm (portable operation)

would require re-certification.

Wireless devices could generate radiation. Other nearby electronic devices, like microwave ovens, may also

generate additional radiation to the user causing a higher level of RF exposure.

The cellular/wireless performance depends on the implementation and antenna design. The integration of the

antenna system into the product is a critical part of the design process; therefore, it is essential to consider it early

so the performance is not compromised. Devices were approved with the following antenna(s) and for alternate

antennas meeting the given specifications.

The antenna system is defined as the UFL connection point from the device to the specified cable specifications

and specified antenna specifications.

Manufacturer:

Manufacturer's Model Number:

Multi-Tech Systems:

Need help?

Do you have a question about the MultiConnect microCell and is the answer not in the manual?