Table of Contents
Advertisement
Installation Instructions Continued
INSTALL INLET PIPE
1.
Connect the elbow to tap and fasten it clockwise.
2.
Connect the other end of inlet pipe to the inlet
valve at the backside of washing machine and
fasten the pipe tightly clockwise. Notes: after
connection, if there is any leakage with hose,
then repeat the steps to connect inlet pipe. The
most common type of tap shall be used to supply
water. If tap is square or too big, then standard
tap shall be changed.
HOLE PLUG
This Hole plug is used to jam the hole on the back
cabinet.
PLACE OUTLET HOSE
There are two ways to place the end of outlet hose:
1.
Put it beside the water trough.
2.
Connect it to the branch drain pipe of the trough.
Position outlet hose properly so that the floor will not
be damaged by water leakage.
NOTE: If the machine has outlet hose support, please
install it like the following pictures.
1.
When installing outlet hose, fasten it tightly.
Position outlet hose properly so that the floor will
not be damaged by water leakage.
2.
Trough
Hose Retainer
Max.100cm
Min.60cm
•
If outlet hose is too long, do not force it into
washing machine as it will cause abnormal noises.
ELECTRICAL CONNECTION
As the maximum current through the unit is 10A
when you are using its heating function, please
make sure the power supply system (current, power
voltage and wire) at your home can meet the normal
loading requirements of the electrical appliances.
•
Please connect the power to a socket which is
correctly installed and properly earthed.
•
Make sure the power voltage at your place is
same to that in the machine's rating label.
•
Power plug must match the socket and cabinet
must be properly and effectively earthed.
•
Do not use multi-purpose plug or socket as
extension cord.
•
Do not connect and pull out plug with wet hand.
•
When connecting and pulling out the plug, hold
the plug tightly and then pull it out. Do not pull
power cord forcibly.
•
If power cord is damaged or has any sign of
being broken, special power cord must be
selected or purchased from its manufacturer or
service center for replacement.
Warning
1.
This machine must be earthed properly. If there is
any short circuit, earthing can reduce the danger
of electrical shock. This machine is equipped with
power cord, which includes plug, earthing wire at
earthing terminal.
2.
The washing machine shall be operated in a
separate circuit from other electrical appliances.
Otherwise, the safety switch may be tripped or
the fuse may be burned out.
7
Advertisement
Table of Contents
