Maintenance - Kogan KA75FNTLDWA Instruction Manual

Maintenance

Maintenance
Before your maintenance starts, please do pull out the power plug or disconnect power
and close the tap.
Before undertaking any maintenance, please pull out the power plug or disconnect power and close the
water tap.
- Solvents are forbidden to avoid that the washing machine is damaged, and toxic gases
WARNING!
are generated or exploded.
- Do not use any solvents, as they may damage the machine, cause toxic gases or cause an explosion.
- Never use water to sprinkle and wash the washing machine.
- Never use water to sprinkle and wash the washing machine.
- It is forbidden that the detergents containing PCMX are used to clean the washing machine.
- It is forbidden to use detergents containing PCMX to clean the washing machine.
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance on the washing machine can extend its working life. The surface can
Cleaning and Maintenance of Washing Machine Cabinet
be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any
Proper maintenance on the washing machine can extend its working life. The surface can be cleaned with
water overflow, use the wet cloth to wipe it off immediately. No sharp items are allowed to
diluted non-abrasive neutral detergents when necessary. If there is any water overflow, use awet cloth to wipe
strike the cabinet.
it off immediately. Avoid the use of sharp objects.
Notes: formic acid and its diluted solvents or equivalent are forbidden.
Notes: formic acid and its diluted solvents or equivalent are forbidden.
Clean Internal Drum
The rusts left inside the drum by the metal articles shall be removed immediately with
Clean Internal Drum
chlorine-free detergents.
Rustleft inside the drum by metal articles shouldbe removed immediately with chlorine-free detergents.
Never use steel wool.
Never use steel wool.
Dispose a Frozen Washing Machine
When the temperature drops below zero and your washing machine gets frozen, you may:
Defrosting a Frozen Washing Machine
1.Disconnect the power supply for the washing machine.
When the temperature drops below zero degrees Celsius and your washing machine is frozen, you may:
2.Wash the tap with warm water to loosen inlet pipe.
1. Disconnect the power supply from the washing machine.
3.Take down inlet pipe and immerse it in warm water.
2.
Wash the tap with warm water to loosen inlet pipe.
4.Pour warm water into washing drum and wait for 10 minutes.
3. Remove inlet pipe and immerse it in warm water.
5.Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
4. Pour warm water into washing drum and wait for 10 minutes.
Notes: when the washing machine is reused, make sure the ambient temperature is above 0 C
Anti-freeze
5. Reconnect inlet pipe to the tap and check whether the inlet and outlet hoses are working normally.
Note:
when the washing machine is reused, make sure the ambient temperature is above 0°C
If your washing machine is located in the room where it can get frozen easily, please drain
the remaining water inside drain pipe and inlet pipe thoroughly.
Anti-freeze Remove the remaining water in inlet pipe:
1.Close the tap.
If your washing machine is in a room where it can get frozen easily, please drain the remaining water inside
2.Screw off the inlet pipe from tap and put its end into the container.
drain pipe and inlet pipe thoroughly.
3.Start up any procedure except single Wash or Drain
procedure. Water will be drained out of inlet pipe if any
Remove the remaining water in inlet pipe:
for about 40 seconds.
1. Turn off the water tap.
4.Reconnect the inlet pipe to tap.
2. Screw off the inlet pipe from tap and put its end into a container.
Remove the remaining water in drain pump
3. Start up any procedure except single Wash or Drain procedure.
Any water will be drained out of inlet pipe for about 40 seconds.
4. Reconnect the inlet pipe to tap.
T
o avoid burning, it shall be done after the hot water
Remove the remaining water in drain pump
inside the machine cools down.
WARNING!
To avoid burning, it shall be done after the hot water inside the machine cools down.
P.22
P.22
16
Ma
I
4
N