Aux In Operation; Care And Maintenance - Jensen JCR-208A User Manual

1. To activate the sleep timer, turn the unit on and tap the MODE button to select AM, FM
radio, nature sound or listening to music via AUX IN.
2. Tap the SLEEP button and the sleep time appears on the display.
3. Repeatedly tap the SLEEP button to select a sleep time. The unit will turn off after 10,
20, 30, 40, 50, 60, 70, 80 or 90 minutes. Wait for 3 seconds after your selection for the
unit to confirm the selection, the unit will play for the selected length of time then
automatically turn off.
4. To cancel the sleep timer, press the SLEEP buttons until timer shows "OFF", the unit
will turn into standby mode immediately.
5. To turn the unit off before the selected length of time, press the POWER
any time.
Notes:
1.) If you tap the SLEEP button in unit standby mode, unit will turn on and play for the
selected length of time then automatically turn off.
2.) To check the remaining sleep time, tap the SLEEP button once.
3.) If you are falling asleep to music from an external device connected to the AUX
input, the sleep timer will shut off the power to this system but it will not turn off the
external device.
This unit provides an auxiliary audio signal input jack for connecting external audio
devices like MP3 players, CD players and iPods (except iPod shuffle 3rd gen) and listen
to your external source through the speakers of this system.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the
cable.
2. Plug one end into the AUX-IN jack located on the back of the unit and the other end
of the cable into the Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the external audio device.
4. Tap the MODE button to select AUX mode, "AUH" will show on display for few
seconds before show current time.
5. The volume level can now be controlled through the main unit. Operate all other
functions on the auxiliary device as usual.
Notes:
1.) If you connected the Line-out Jack of your external device then you only need to
adjust the volume control of this system. If you connected the Headphone Jack of
your external device then you may need to adjust both the volume control of your
external device and the volume control of this system to find the most desirable
volume setting.
2.) Remove the audio cable from AUX IN jack when you finish listening. Don't forget
to switch off the power on your external device as well.
1. If the cabinet becomes dusty, wipe the exterior with a soft dust cloth only. Never

AUX IN OPERATION

CARE AND MAINTENANCE

E-10
button at