Important Notes; Power Source - Jensen JCR-208A User Manual

- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Avoid installing the unit in locations described below:

Places exposed to direct sunlight or close to heat radiating appliances such
as electric heaters.

Dusty places.

Places subject to constant vibration.

Humid or moist places.
This unit is designed to operate on 120V~ 60Hz AC house current. Operating this unit on
any other power source may cause damage to the unit, and such damage is not covered
by your warranty.
It is also equipped with a battery back-up system for the clock that is powered by 2 X AAA
(UM-4) batteries (not included).
BATTERY BACK-UP SYSTEM
The Battery Back-up System ensures the clock and alarm settings will be retained during a
power interruption or power outage (in order to preserve the battery life the Display will not
light). All clock settings will be kept in memory, however, the clock time may require
adjustment for exact accuracy once the power returns. If the batteries are not installed, the
Display will blink"12:00" when the power is restored. This will indicate that you have to reset
the time and alarm settings.
BATTERY INSTALLATION
1. Open the battery compartment door on the bottom of the cabinet.
2. Follow the polarity diagram shown inside the compartment and Install 2 X "AAA" size
batteries (not included).
3. Replace the Battery Compartment Door.
IMPORTANT: Be sure that the batteries are installed correctly. Wrong polarity may
NOTE: Only use a well-known brand of battery to ensure longest life and best performance.
CAUTIONS
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

IMPORTANT NOTES

POWER SOURCE

damage the unit.
E-3