Maxon SL7000 Series Operational Description page 34

SL7000SERIES HAND HELD
Press delete key to remove 5-tone code from the list.
- RX Code List
According to the signaling operation, RX Code List is used differently. If ANI is selected and the received code is in
RX code List, then the corresponding text will be displayed. If Selcall is selected and the received code is in RX Code
List, then the corresponding actions(including the text display) will be carried out.
First Tone Delay Time
-
This time is programmable 0 to 1000ms at 50ms intervals. The transceiver transmits 5-tone after this duration
elapsed.
Auto Reset Time
-
This time is programmable 1 to 255 seconds at 1 second intervals. The transceiver carries out predefined actions if a
valid code is received. If there is no response about the actions within this time, then the transceiver stops current
actions automatically.
Remind Time
-
This time is programmable 1 to 255 seconds at 1 second intervals. 'CALL' displays during this time if there is no
response within Auto Reset Time. This function informs user, the transceiver received a call in the absence of the
user.
- Code List Display Type
You can choose between Code and Text for code display type. This applies in 5-tone code select mode.
* Edit – How to Program
Ready for program
-
Make sure that COM port is set correctly.
Turn on the transceiver.
Connect the transceiver and PC with a communication cable.
In case of writing, a group must have at least 1 channel, otherwise error message window appears.
Program
-
The status messages display during program.
In proportion as transmitted data, the progress gauge display proportionally. The gauge color is determined by the
current job(writing or reading). This is almost same with the transceiver's LED color.
The transceiver tries to reset after the writing is finished.
34