Related Manuals for Maxon SMX-4150
Summary of Contents for Maxon SMX-4150
- Page 1 SMX-4150 OPERATOR’S MANUAL INTRODUCTION The SMX-4150 series mobile has 16 Channel capability, (enhanced to 99 with the selcall board fitted), with CTCSS and optional DCS signalling systems.. FRONT PANEL CONTROLS, SWITCHES AND INDICATORS...
- Page 2 ON/OFF/VOLUME CONTROL • turns the SMX-4150 on/off and adjusts the audio output level SQUELCH CONTROL • silences the radio's receiver when no signal is being received • maximum squelch setting is at full clockwise rotation CHANNEL CHANGE BUTTONS • assigned (programmed) channels may be selected by pressing either of the channel selector buttons;...
-
Page 3: Radio On/Off, Power Up
Do not adjust the squelch control while other parties are using the channel. NOTE: If your SMX-4150 is equipped with tone or digital coded squelch options, depress the Monitor Button/LED 2 to enable the option, the CALL LED will no longer be illuminated. -
Page 4: Transmit Time-Out-Timer
NOTE: If your SMX-4150 is equipped with SELCALL, refer to additional instructions for correct operation. TRANSMITTING 1. Turn the radio on and select the desired frequency by pressing either of the channel select buttons until the channel number is visible in the display. -
Page 5: Error Messages
The range for the time-out period is 10 seconds to 990 seconds (in 10 second increments). TRANSMIT INHIBIT ON BUSY CHANNEL (BUSY CHANNEL LOCK- OUT) If your radio has this option enabled, press the PTT Bar while carrier is present (Busy LED ON or Busy and Call LEDs ON). This will cause all transmitter functions to be disabled, including the TX LED, and a warning tone to be generated. - Page 6 NOTE: Should any of these messages appear on your display, MAXON recommends that you consult the dealer from whom the unit was purchased so that it can be serviced by a qualified service technician.
- Page 7 REAR PANEL CONNECTORS A) EXTERNAL SPEAKER CONNECTOR A 3.5mm diameter jack is provided for a 4 ohm external speaker. The internal speaker is silenced when the external speaker is connected. B) AUXILIARY SPEAKER CONNECTOR A 3.5mm diameter jack for a 4 ohm auxiliary speaker. C) ANTENNA CONNECTOR SO-239 type connector.
- Page 8 - All equipment must be properly grounded according to MAXON installation instructions for safe operation. - All equipment should be serviced only by a qualified technician. Refer to the appropriate section of the product service manual for additional pertinent safety information.