Chlorination; Default Display - Hayward Goldline Controls Aqua Logic AQL-P-4 Operation Manual

Chlorination

With the use of the optional AQL-CL chlorination kit, the Aqua Logic is also an automatic chlorine genera-
tion system for pool and/or spa sanitization. If enabled (see Configuration Menu), this operation requires
a low concentration of salt (sodium chloride) in the pool/spa water. The Aqua Logic automatically con-
verts the salt into free chlorine which kills bacteria and algae in the pool/spa. Chlorine will revert back to
sodium chloride after killing bacteria. These reactions will continuously recycle, virtually eliminating the
need to add sanitizing chemicals to your pool/spa. The only time you may need to add more salt to the
pool/spa is when water is replenished due to backwashing, draining, or splashing (not evaporation).
The Aqua Logic is designed to handle the purification needs of most residential swimming pools up to
40,000 gallons (150,000 liters), or the needs of most commercial pools up to 25,000 gallons (95,000
liters). Check local codes for other restrictions. The actual amount of chlorination required to properly
sanitize a pool varies due to bather load, rainfall, temperature, and the pool's cleanliness.
For pools larger than 40,000 gallons, the Aqua Logic can control one or more Goldline Aqua Rite chlori-
nators to supplement chlorine production.
NOTE: Before installing this product as part of a saline water purification system in a pool or spa using
natural stone for coping or for immediately adjacent patios/decking, a qualified stone installation specialist
should be consulted regarding the appropriate type, installation, sealant (if any) and maintenance of stone
used around a saline pool with electronic chlorine generator in your particular location and circumstances.

Default Display

Turn power on at the main panel and turn the Aqua Logic control power circuit breaker on. The keypad
will show the default display. The default display alternates between the day/time, air and pool (or spa)
temperature, pool/spa sanitizer setting, and salt level. Under certain circumstances, additional displays
may be added to the default menu to inform you about system operation. Refer to the Programming Menu
Flowchart on page 6 to view all possible displays. The Aqua Logic will automatically scroll through all of
the available default menu displays or you can press "<" or ">" to manually scroll.
Saturday
11:45A
+
Service
>
Menu
2
Pool/Spa
Filter
Lights
Aux 1
Aux 2