Aerotech PRO22SL Hardware Manual page 14

Chapter 1: Overview
PRO225SL and PRO225SLE Series Linear Ball-Screw Stage (continued)
Foldback (Optional)
-FB1
Motor Orientation (Optional)
-2
-3
-4
-5
-8
-12
Limits (Required)
-LI1
-LI2
-LI3
Coupling (Optional)
-CP1
Lifting Hardware (Optional)
-LF
NOTE: Lifting option only available on travels 300 mm and greater. Lifting should never be ordered on the upper-axis of
an XY set (only order on lower-axis).
ThermoComp™ (Optional)
-TCMP
NOTE: You must use an Automation1 or A3200 controller with the -TCMP option.
Metrology (Required)
-PL0
-PL1
-PL2
Accessories (To be Ordered as a Separate Line Item)
ALIGN-NPA
ALIGN-NPAZ
ALIGN-PA10
ALIGN-PA10Z
ALIGN-PA5
ALIGN-PA5Z
HDZ225
14
Foldback kit for 1/2" diameter shaft NEMA 34 motor
Bottom cable exit, optional orientation
Left-side cable exit, standard orientation
Top cable exit, optional orientation
Right-side cable exit, optional orientation
Right-side foldback, standard orientation
Left-side foldback, optional orientation
Normally-closed limit switches; 5 VDC with 9-pin D connector
Normally-open limit switches; 5 VDC with 9-pin D connector
Normally-closed limit switches; 24 VDC with 9-pin D connector
Coupling for 1/2" diameter shaft
Lifting hardware
ThermoComp™ integrated thermal compensation unit
No metrology performance plots
Uncalibrated with performance plots
Calibrated with performance plots
Non-precision XY assembly
Non-precision XZ or YZ assembly
XY assembly; 10 arc sec orthogonality; alignment to within 7 µm orthogonality for short
travel stages
XZ or YZ assembly with L-bracket; 10 arc second orthogonality; alignment to within 10 µm
orthogonality for short travel stages
XY assembly; 5 arc sec orthogonality; alignment to within 3 µm orthogonality for short
travel stages
XZ or YZ assembly with L-bracket; 5 arc second orthogonality; alignment to within 5 µm
orthogonality for short travel stages
Right angle L-bracket for 100 mm, 150 mm, and 200 mm travels only
PRO225SL/SLE Hardware Manual
www.aerotech.com