Advertisement
Biological hazard. Obey safety handling protocols and wear all of the personal protective equipment
required when handling an instrument that may have come in contact with biological hazardous
materials. Wash and decontaminate the instrument with a disinfectant soap solution and rinse with hot
water before maintenance or shipping.
Clean the instrument
Clean the exterior of the instrument with a moist cloth and a mild soap solution and then wipe the
instrument dry as necessary.
Replace the fuse
Electrocution hazard. Always remove power to the instrument before making electrical connections.
Fire hazard. Use the same type and current rating to replace fuses.
1. Remove the cover.
2. Remove the fuse from the fuse holder. Refer to
3. Install a new fuse of the same type and current rating. Refer to
fuse rating.
4. Install the cover.
Pump maintenance
It is important to keep the sampler pump and tubing in good condition to prevent leaks from the
pressurized sample.
• Do not operate the pressurized sampling relay during tubing or pump maintenance.
• For an AWRS that has a compartment heater, obey the precautions in
precautions for an AWRS
1. Close the valve in the high-pressure sample line to stop the flow of the pressurized sample.
2. Disconnect the auxiliary cable from the relay module to the sampler.
3. Complete the pump maintenance instructions in the sampler documentation.
4. Connect the auxiliary cable from the relay module to the sampler.
Replacement parts
Personal injury hazard. Use of non-approved parts may cause personal injury, damage to the
instrument or equipment malfunction. The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the appropriate distributor or refer to
the company website for contact information.
W A R N I N G
D A N G E R
W A R N I N G
on page 17.
W A R N I N G
Figure 1
on page 5.
Specifications
on page 3 for the
Pressurized sample
English 19
Advertisement
