Advertisement
4. If more than 25.4 mm (1 inch) of the cable jacket is removed, install a plastic wire tie around the
wires. Install the wire tie at a maximum distance of 19 mm (0.75 inch) from the terminal. Refer to
Figure
7.
5. Tighten the cable strain relief sufficiently to keep the environmental rating of the enclosure.
6. Install the cover. Make sure that the screws are tight to keep the environmental rating of the
enclosure.
7. Refer to the user documentation for the sampler controller to set up flow pacing.
Figure 7 Wiring for flow pacing
1 Length of the removed cable jacket
2 12/15 VDC terminal
3 Pulse/mA input terminal
4 Common terminal
Figure 8 Self-powered 4–20 mA transmitter
1 Low-voltage block (TB1)
2 Common terminal (–)
5 Shield/drain terminal
6 Cable tie
7 Cable to the external device
3 Pulse/mA input terminal (+)
4 4–20 mA transmitter
English 13
Advertisement
