Advertisement
Figure 12 AWRS compartment drain
1 Center cable slot
Operation
Configure the sampler
Configure the sampler controller for pressurized sampling. When pressurized sampling is selected,
the liquid detector is disabled.
1. Go to Hardware Setup.
2. Select AUX and I/O Port.
3. Configure the options as follows:
Option
Mode
Valve Cycle Time 10 seconds (default). This is the time that is necessary for the ball valve to move from
Flow Reading
Maintenance
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
18 English
Setting
Pressurized
one position to the other. The use of a value less than that specified by the valve
manufacturer can cause incorrect rinse, purge or sample function.
AUX-Pulse or AUX-mA
2 Compartment heater
D A N G E R
Advertisement
