Closing The Bus - Volvo 9700 US/CAN 2016 Driver's Handbook Manual

8 Doors and hatches

Closing the bus

To close the bus proceed as follows:
1 Select neutral position on the gear selector.
2 Engage the parking brake.
3 Turn on the switch that activates the door
opening push-button in the door handle.
4 Open the door.
5 Turn OFF the power supply with the
ignition key in position 0, to refer see the
following section in this manual: "Ignition
switch", page 46.
6 Leave the bus and close the door using the
push-button in the door handle.
7 Lock the door with the key.
Note: After locking the door with the key,
the push-button in the door handle becomes
inactive.
After turning off the power supply with the
ignition switch, the light above the entrance
door remains on for about 90 seconds.
If the button activating the button in the
handle for opening the door is not switched
on, in order to enter the bus again, the
emergency valve must be used.
Parking brake lever control.
T1008555
Button for outside opening of the service
door.
T5014881