Direction Indicator - MG GT Manual

1 The master lighting switch must be in the Auto
position and the dipped beam lamps switched on via
automatic control.
2 The vehicle is running and the speed is above 40km/h.
If the following conditions are met, the vehicle will
automatically exit the smart main beam system. If the
system exits, quickly push the main beam on switch twice
towards the instrument dial to enter the smart main beam
system again. You can only exit three times in one ignition
cycle. If you exit more than three times, you cannot enable
this function again in the current ignition cycle.
• When the smart main beam system is enabled and the
dipped beam lights are automatically turned on, it is
manually switched to the main beam lights.
• When the smart main beam system is enabled and
the main beam lights are automatically turned on, it is
manually switched to the dipped beam lights.
• When the smart main beam system is enabled and the
main beams are automatically turned on, turn the main
beam flash switch.
34
Instruments and Controls

Direction Indicator

IMPORTANT
The smart main beam function uses data from the front
view camera, always keep the windscreen clean and
free from residue in this area to maintain optimum
performance of this system. Any damage in this area,
such as stonechips must be repaired at the earliest
convenience.
2
1