Parking Aid; Ultrasonic Sensor Parking Aid - MG GT Manual

Parking Aid

Ultrasonic Sensor Parking Aid

The purpose of the parking aid is to assist the
driver in parking! The sensors may not be
able to detect certain types of obstruction,
e.g. narrow posts or small objects no more
than a few inches wide, small objects close to
the ground, objects above the trunk and some
objects with non-reflective surfaces.
Keep the sensors free from dirt, ice and snow.
If deposits build up on the surface of the
sensors, their performance may be impaired.
When washing the car, avoid aiming high
pressure water jets directly at the sensors
from close range.
Rear Parking Aid
The ultrasonic sensors on the rear bumper monitor the
area behind the vehicle to search for obstacles. If an
obstruction is detected, the system calculates its distance
Starting & Driving
from the rear of the car and communicates this information
to the driver by an alarm sound.
Parking Aid Operation
Rear Parking Aid
Select the R gear, and the rear parking aid will start working
automatically. When exiting R gear, the system will be
off. A short beep is given by the parking aid within 1
second after selecting R gear to indicate that the system
is operating normally. When any rear obstacle is detected,
the system will make an alarm sound to prompt the driver.
Note: If a longer, higher pitched alarm sound is
emitted for 3 seconds when R gear is selected, this
indicates a fault in the system. Seek assistance from
your MG Authorised Repairer.
4
183