MG GT Manual page 132

ISOFIX Child Restraint Systems
The ISOFIX anchorages in the rear seat are
designed for use with ISOFIX systems only.
Child restraint anchorages are designed
to withstand only those loads imposed by
correctly fitted child restraints. Under no
circumstances are they to be used for adult
seat belts, harnesses, or for attaching other
items or equipment to the vehicle.
Note: When installing and using any child restraint
system, always follow the manufacturer's instructions.
Note: The rear seats fitted to this vehicle are provided
with the ISOFIX interface (as indicated by the arrow in
the following image), these are designed to connect to
an ISOFIX child seat.
1 Fasten vehicle-approved ISOFIX child restraint
systems to the mounting brackets.
2 When using ISOFIX mounting brackets for seat
mounting, universally approved child restraint systems
for ISOFIX may be used.
118
Seats & Restraints
3 The top-tether (as arrowed in the figure above) for
auxiliary fixation of the child restraint is provided
on the rear parcel shelf of the vehicle. The single
top-tether of the child restraint must pass through
space between the rods of the rear seat headrest, and
dual tether must pass from both sides of the rear seat
headrest.