Table of Contents
Advertisement
far away from the battery as possible and well away
from fuel and brake lines on the disabled vehicle (B).
2 Start the donor vehicle and allow it to run for a few
minutes.
3 Start the disabled vehicle. If the disabled vehicle does
not start after several attempts, it may need to be
repaired. Please contact an MG Authorised Repairer.
4 After
both
the
started/powered, turn off the START/STOP Switch of
the donor vehicle.
5 Disconnecting the booster cables must be an exact
reversal of the procedure used to connect them, i.e.
disconnect the BLACK cable from the earth point on
the disabled vehicle FIRST.
IMPORTANT
DO NOT switch on any electrical appliance in the
disabled vehicle until the booster cables have been
disconnected.
200
Emergency Information
vehicles
have
normally
Note: It is recommended to ensure that the disabled
vehicle remains powered or runs for more than 1 hour
after it is started, in order to recover the battery power.
Advertisement
Table of Contents
