Putting the Mast into the Transport Position
With the machine safely in position on the trailer, the park
brake engaged and the transmission in neutral, do the
following:
1
Unfasten both tilt cylinder restraint wires from the
mast.
a Unscrew and remove bolt A and washer B from
each mast tilt cylinder pivot pin.
b Remove the restraint wires C (if fitted).
Fig 64.
2
With the engine running, operate the controls to raise
the carriage 200mm (8 in) from it's lowest position.
3
Tilt the mast fully forward. Make sure the forks do not
foul on the trailer bed.
81
K Fig 65. ( T
81).
9811/5700-7
Operation
Transporting the Machine
Fig 65.
81