jcb RTFL 926 Operator's Manual page 78

6 Check that it is clear behind you, then slowly reverse
the machine away in first gear.
7 Stop the machine. Engage the park brake. Put the
transmission in neutral. Put the mast and carriage
into the travel position.
8 Carefully drive the machine to the unloading point.
Fig 49.
68
Unloading on the Ground
Never unload the forks by stopping the machine
suddenly. Follow the procedures in the Operator
Manual for unloading.
5-1-4-4_2
1 Approach the unload area on centre, with the rear
wheels straight. Stop the machine with the load
directly over the unload point.
2 Engage the park brake. Put the transmission in
neutral.
3 Set the forks level with the ground and lower the load
into position.
4 Lower the forks a little more to clear the pallet. Tilting
the mast forward a little may help at this stage.
5 Check that it is clear behind you, then slowly reverse
the machine away in first gear.
6 When the forks are clear of the load, stop the
machine. Engage the park brake and put the
transmission in neutral.
7 Put the mast and carriage into the site travel position.
9811/5700-7
Operation
Working with the Machine
!M
CAUTION
Unloading
Fig 50.
68