jcb RTFL 926 Operator's Manual page 106

Mast Tilt Rams
Mast Lift Ram
Mast Chains
Mast Chains Adjustment (6)
(6)
Mast Chains
Mast and Carriage Rollers
Mast Pulleys
Mast Roller Guides (6)
Mast Sections
Forks - Condition and Heel Thickness
All Hinges
All Cables
All Linkage Points
Roof and Screen Guards
FOPS Structure
Windscreen Washer Fluid Level
Condition of Paintwork
Seat Belt Condition and Security (If fitted)
Machine Generally
ATTACHMENTS
Optional Attachments as needed - see
manufacturer's instructions
For Fit and Security
(1) First 100 Hours Service only, to be completed by your JCB Distributor.
(2) If operating under arduous conditions, change the engine oil and filter every 250 hours.
(3) The oil service interval will be affected if there is a high sulphur content in the fuel. Refer to Fuel System for more
information.
(4) More frequently if operating in dusty working environments.
(5) If the engine is difficult to start or the engine has poor performance, fit new filters.
(6) Jobs which should only be done by a specialist.
(7) After a major transmission repair, the new oil should be run to operating temperature and changed again to remove
any contamination which entered during the repair. Change the oil and filter after a further 100 hours if the oil was
heavily contaminated because of, or from the failure (e.g. water contamination).
(8) Check tightness of the wheel nuts every day for first week (when machine is new), thereafter every 50 hours.
96
- Check for Wear and
(6)
- Check for Damage
Operation 10 50
 
- Grease
 
- Grease
- Grease
- Check
Stretch

- Check

- Check
- Check
- Check
- Check

- Lubricate

- Lubricate

- Lubricate
- Check
 
- Check
 
- Check
- Check
 
- Check
 
and Clean
- Check

- Check
9811/5700-7
Routine Maintenance
Service Schedules
(1) 100 500 1000 2000 6000
   
   
   
   
   
   
   
   
   
   
   
   
   
  
   
   
   
   
   
   





















96