jcb RTFL 926 Operator's Manual page 79

Unloading Above Ground Level
Unload above ground level only after you fully understand
how to handle palleted loads. The basic procedure is the
same, but remember the following points:
K Stacking Loads ( T
72).
1 Approach the unload area on centre, with the rear
wheels straight. Stop the machine, just in front of the
stack (or platform).
2 Raise the load until it is a few inches higher than the
stack or platform.
1
Fig 51.
3 Drive forward in first gear until the load is directly
above its required position. Stop the machine.
Engage the park brake. Put the transmission in
neutral.
4 Set the forks level with the unload area and lower the
load into position.
5 Lower the forks a little more to clear the pallet. Tilting
the mast forward a little may help at this stage.
69
6
2
7
8
9811/5700-7
Working with the Machine
Fig 52.
Check that it is clear behind you, then slowly reverse
the machine away in first gear.
When the forks are clear of the load, stop the
machine. Engage the park brake and put the
transmission in neutral.
Lower the forks. Put the mast and carriage into the
site travel position.
Operation
69