Debug And Trace Configuration; St-Link Debugger; Trace With Ulinkpro - STMicroelectronics STM32F756G-EVAL Quick Start Manual

Debug and Trace Configuration

STMicroelectronics STM32F756G-EVAL Board

ST-Link Debugger

Trace with ULINKpro

For full trace capability, connect a ULINKpro to the board's Trace connector and choose ULINK
Pro Cortex Debugger. Configure ETM trace for instruction tracing:
Note: You need to lower the core clock as trace is not supported for clock frequencies above 180
MHz on this microcontroller device.
More Information
 Getting Started User's Guide
 Connect using Serial Wire
Debug (SWD) by
selecting the Port SW.
 Configure ITM Trace by
selecting the Trace tab
and enter the correct
CPU Core Clock speed
as specified in your
project. Check the Trace
Enable box.
www.keil.com/gsg
Copyright © 2015 ARM Ltd. All rights reserved.