Download Print this page

Billy Goat MV650SPHEU Owner's Manual page 7

Advertisement

MVSPEU Owner's Manual
OPERATION
This vacuum is designed for picking up trash, organic material and other similar debris. It should not be used for other purposes
than what is intended.
OPERATOR CONTROLS
The operator's position is at the rear of the machine between the handlebars. The operator should STAND in a position to allow
both handlebars to be grasped firmly, which allows sufficient leverage to steer the machine. Operator's controls are shown below.
STARTING
CHECK engine oil level before operating machine.
DO NOT START equipment without the debris bag in place.
1. Place equipment on a level, firm surface that is free of rocks or other
debris.
2. Place throttle in START position.
3. Secure the unit with left hand at the handle then pull starter rope with right
hand to start engine. NOTE: Pull starter cord slowly until resistance is felt.
Then pull cord rapidly to avoid kickback.
4. Move throttle control back to FAST position and allow engine to reach
correct operating speed.
5. For Electric models: Set the throttle to the fast position, then pull up and
push forward on the start switch. Choke if needed.
SHUT DOWN
1. Release the drive clutch lever to disengage the drive.
2. Pull the throttle control all the way back to the STOP position.
Part No 840286
1
2
Operator Control Locations
1 Drive Clutch Lever
4 Throttle Control
Secure unit at the handle with left
hand during start.
On Electric
models only.
2 Bag Latch
3 Pull Starter
5 Drive Shifter Control
Pull rope starter with right
hand.
7
3
4
6
5
6 Nozzle Door Adjuster
Fig. 8
Fig. 9
840286_B_HI

Advertisement

loading

This manual is also suitable for:

Mv601speeuMv650sphdseu