Advertisement
Quick Links
MVSPEU Owner's Manual
Self-Propelled Multi-Vac Owner's Manual
MV650SPHEU, MV601SPEEU, and MV650SPHDSEU
CASTER KIT
Use on hard surface
For vacuuming hard
for maneuverability.
P/N 840129
IMPORTANT- READ CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE.
Part No 840286
Accessories
HOSE KIT
BAG LINER KIT
To collect leaves,
to reach areas.
thatch, and grass.
P/N 840116
P/N 840134
Original Instructions
FELT BAG KIT
Use on all dusty
conditions.
P/N 840194
1
LINER KIT
Interior housing liner
to decrease housing
wear.
P/N 840201
840286_B_HI
Advertisement
Related Manuals for Billy Goat MV650SPHEU
Summary of Contents for Billy Goat MV650SPHEU
- Page 1 MVSPEU Owner’s Manual Self-Propelled Multi-Vac Owner’s Manual MV650SPHEU, MV601SPEEU, and MV650SPHDSEU Accessories CASTER KIT HOSE KIT BAG LINER KIT FELT BAG KIT LINER KIT Use on hard surface For vacuuming hard To collect leaves, Use on all dusty Interior housing liner for maneuverability.
- Page 2 MVSPEU Owner’s Manual CONTENTS SPECIFICATIONS AND SAFETY INSTRUCTION LABELS ASSEMBLY INSTRUCTIONS OPERATION MAINTENANCE AND TROUBLESHOOTING 10-15 ILLUSTRATED PARTS LIST 16-24 Part No 840286 840286_B_HI...
- Page 3 MVSPEU Owner’s Manual SPECIFICATIONS MV650SPHEU MV601SPEEU MV650SPHDSEU Engine Type Honda GSV190LN1L Briggs and Stratton Honda GSV190LN1L Professional Series 125P070039H5 Horsepower 6.5 (4.85 kW) 5.0 (3.73 kW) 6.5 (4.85 kW) Fuel Capacity 1.6 qt (1.5 L) 1.0 qt. (0.95 L) 1.6 qt (1.5 L) 0.625 qt.
- Page 4 INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT MV Vacuum. If any labels are damaged or missing, replace them before operating this equipment. For your convenience in ordering replacement labels, part numbers are included in the Illustrated Parts List.
- Page 5 MVSPEU Owner’s Manual ASSEMBLY INSTRUCTIONS ® Your BILLY GOAT MV Vacuum was shipped in one carton, completely assembled except for the Hood/Upper Handle Assembly. Mounting hardware for the Hood/Upper Handle Assembly is temporarily installed on the lower handle and the Housing Assembly.
- Page 6 MVSPEU Owner’s Manual Fig. 3 Fig. 4 HERE HERE Fig. 5 Fig. 6 Fig. 7 Part No 840286 840286_B_HI...
- Page 7 MVSPEU Owner’s Manual OPERATION This vacuum is designed for picking up trash, organic material and other similar debris. It should not be used for other purposes than what is intended. OPERATOR CONTROLS The operator’s position is at the rear of the machine between the handlebars. The operator should STAND in a position to allow both handlebars to be grasped firmly, which allows sufficient leverage to steer the machine.
- Page 8 MVSPEU Owner’s Manual VACUUM NOZZLE HEIGHT ADJUSTMENT For maximum pickup: Adjust nozzle height as close to debris as possible, but without blocking airflow into the nozzle. NOTE: Never bury nozzle into debris. The vacuum nozzle is raised and lowered by turning the crank handle clockwise and counter-clockwise (See Fig.
- Page 9 MVSPEU Owner’s Manual DEBRIS BAG Debris bags are normal replaceable wear items. Bag liners are available for use in various conditions where debris will be vacuumed. (See Bag Liner Accessories shown on pg 1). MV650SPHDSEU Only – The dust sock provided will trap dust when vacuuming up dry debris only. The dust sock will need to be removed periodically and the dust will need to be dumped out as it will accumulate over time.
- Page 10 MVSPEU Owner’s Manual MAINTENANCE PERIODIC MAINTENANCE Periodic maintenance should be performed at the following intervals: Maintenance Operation Every Daily or Every 25 Every 50 Every 100- Every 5 Hours Hours 150 Hours Hours Inspect for worn or damaged parts Check for excessive vibration ...
- Page 11 MVSPEU Owner’s Manual IMPELLER REMOVAL READ all safety instructions before servicing unit. DISCONNECT spark plug wire before servicing unit. 1. Wait for engine to cool and disconnect spark plug. 2. Drain fuel and oil from the engine. 3. Remove belt cover by removing 5 screws. 4.
- Page 12 MVSPEU Owner’s Manual cable adjustment Loosen 4" Tighten from handle 1 1/8" Fig. 18 Fig. 19 DRIVE BELT REMOVAL AND REPLACEMENT READ all safety instructions before servicing unit. DISCONNECT spark plug wire before servicing unit. Wait for engine to cool completely and disconnect spark plug. Remove guard fasteners and guard.
- Page 13 MVSPEU Owner’s Manual Rotate the axle several times and listen for “popping” or “clacking”. This indicates too much tension on the chain or misalignment of the chain. Skip to Step 12 if no “popping” or “crackling” occurs. Improper Chain Tension At the point where the chain is tightest, check the chain for ¼”...
- Page 14 MVSPEU Owner’s Manual TROUBLESHOOTING Problem Possible Cause Solution Will not vacuum or has poor Dirty or full debris bag or filter. Clean debris bag and filter. Shake bag vacuum performance clean or wash. Nozzle height set too high or too low. Adjust nozzle height (see page 8).
- Page 15 MVSPEU Owner’s Manual MAINTENANCE RECORD Date Service Performed Part No 840286 840286_B_HI...
- Page 16 MVSPEU Owner’s Manual MVSPEU NOZZLE PARTS DRAWING Nozzle Assembly Part No 840286 840286_B_HI...
- Page 17 MVSPEU Owner’s Manual MVSPEU NOZZLE PARTS LIST PART MV650SPHEU MV601SPEEU MV650SPHDSEU ITEM NO. NUMBER DESCRIPTION QTY. QTY. QTY. 350127 YOKE 1/2 - 20 350128 PIN YOKE 1/2" 840243 SCREWCAP BUTTON HEAD 3/8"-16 X 1 1/4" PL 8172009 WASHER 3/8" SAE ZP...
- Page 18 MVSPEU Owner’s Manual MVSPEU TRANS PARTS DRAWING Drive /Rear Axle Assembly Part No 840286 840286_B_HI...
- Page 19 MVSPEU Owner’s Manual MVSPEU TRANS PARTS LIST PART MV650SPHEU MV601SPEEU MV650SPHDSEU ITEM NO. NUMBER DESCRIPTION QTY. QTY. QTY. 840110 BRACKET TRANS MOUNT WA MV VAC 350133 BEARING 3/4" W/PILLOW BLOCK 840009 DIFFERENTIAL 54 TOOTH D-CUT 840086 BRACKET TRANS ANTI ROTATION MV 840010 GUARD DRIVE SP VAC 840085 TRANSMISSION 3 SPD GENERAL TRANS.
- Page 20 MVSPEU Owner’s Manual MVSPEU ENGINE PARTS DRAWING Engine Assembly Part No 840286 840286_B_HI...
- Page 21 MVSPEU Owner’s Manual MVSPEU ENGINE PARTS LIST ITEM PART MV650SPHEU MV601SPEEU MV650SPHDSEU NUMBER DESCRIPTION QTY. QTY. QTY. 840282 ENGINE 6.5 HP HONDA GSV190 B4 1/1/19- EU 840283 ENGINE B&S SERIES 875Exi ELEC START 840100 IMPELLER 12.75 WA SP VAC 840107...
- Page 22 MVSPEU Owner’s Manual MVSPEU HOOD PARTS DRAWING Hood Assembly Part No 840286 840286_B_HI...
- Page 23 MVSPEU Owner’s Manual MVSPEU HOOD PARTS LIST ITEM PART MV650SPHEU MV601SPEEU MV650SPHDSEU NUMBER DESCRIPTION QTY. QTY. QTY. 440013 CONTROL THROTTLE 840023 CONTROL SHIFT WESCON MV VAC 840265 HANDLE MV CLUTCH CABLE 500176 LABEL CLUTCH DRIVE 840141 HOOD ASSY W/ LABEL MV VAC...
- Page 24 MVSPEU Owner’s Manual ITEM PART MV650SPHEU MV601SPEEU MV650SPHDSEU NUMBER DESCRIPTION QTY. QTY. QTY. 840040 ROD BAG WA MV VAC 840139 LATCH RUBBER ASSEMBLY MV VAC 840016 LATCH RUBBER MV VAC 360203 PAL NUT 0.312 840189 BAG DEBRIS MV VAC 840260...