Advertisement
36 - Install the pedals
Identify the left (drive side) right (non-drive side) pedals by
the markings on the threaded axle. The drive side (the side
that the chain is on) is clockwise threaded, the non-drive
side is counter clockwise threaded. Install the pedals on the
appropriate side.
38
Determine if you would like to have the U-tubes installed in
the wide setting (shown on the left side of the bike pictured
below) or the narrow setting (shown on the right side). In the
wide setting, the U-tubes will extend 6" out from the frame. In
the narrow setting, they will extend 5.25" out from the frame.
37 - Install the U-Tubes
Before installing the U-Tubes, please take note that the
rear insertion end on each U-Tube is slightly longer than the
insertion end on the front end of the U-Tube.
If you would like to switch the width setting
on your U-Tubes to narrow or wide:
Press the spring pin button in and push or pull the spring pin
elbow on the inside of the U-Tube until the spring pin button
pops out and into the setting hole. Needlenose pliers might
be needed to help with this.
Wide
setting
hole
Narrow
setting
hole
11
Advertisement
