Singer ES-850B Instruction Manual page 8

the handle of the funnel aligns with groove in the appliance, then insert
the funnel into the appliance from the "Insert" position. You can fi x them
into coffee maker fi rmly through turn it anticlockwise until it is at the "Lock"
position.
3. Place an espresso cup on removable shelf.
4. Then connect the appliance to power supply. Make sure the steam control
knob is on the OFF position.
5. Press the power button " " one time, the red indicator is illuminated,
press the coffee/steam selector on the "
control button on the "
the pump immediately. The purpose of the step is to pump the water of the
tank into the housing.
6. When the lamp in pump control switch is illuminated, you should press the
pump control switch on the "
fl owing out. When the lamp it is extinguished, close the pump. The pre-
heating is fi nished.
MAKE ESPRESSO
1. Remove the funnel by turning it in clockwise. Add ground coffee to steel
mesh with measuring spoon, a spoon ground coffee powder can make
about a cup of top-grade coffee, then press the ground coffee powder
tightly with the tamper.
2. Set steel mesh into metal funnel. Make sure that the handle of the
funnel aligns with groove in the appliance, then insert the funnel into the
appliance from the "Insert" position. You can fi x them into coffee maker
fi rmly through turn it anticlockwise until it is at the "Lock" position.
3. Pour hot water in the cup. Then place the hot cup on removable shelf.
4. At the time, the lamp in pump control switch shall be illuminated, if it is
extinguished, wait for a moment. Once the lamp in it is illuminated, you
should press the pump control switch on the "
moment, there will be coffee fl owing out.
Note: During operation, if the indicator is extinguished, you must close
the pump and stop to make espresso coffee. After a few seconds, if the
lamp is illuminated again, you can make espresso coffee continued by
pressing pump control switch to "
" position, when there is water fl owing out, close
" position again, there will be hot water
" position, the lamp is cycle on and
8
ENGLISH
" position. Press the pump
" position, wait for a