Singer ES-850B Instruction Manual page 7

Espresso-cappuccino machine
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
BEFORE THE FIRST USE
To ensure the fi rst cup of coffee tastes excellent, you should rinse the coffee
maker with warm water as follows:
1.
Pour water into water tank, the water level should not exceed the "MAX"
mark in the water tank. Then place the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning,
you can fi ll the tank with water fi rstly, and then put the tank into the
appliance.
2.
Set steel mesh into metal funnel (no coffee in steel mesh).
3.
Place a jug on removable shelf. Make sure the steam control knob is on
the OFF position.
Note: the appliance is not equipped with jug, please use your own jug or
coffee cup.
4.
Connect to power source. Press the power button "
indicator is light up.
5.
Press the pump control switch to the "
water. When there is water fl owing out close the pump by pressing the
pump control switch to "
"
" position and wait for a moment. The appliance begins to be pre-
heated until the inner lamp of pump control switch is illuminated, it shows
the pre-heating is fi nished. Press the pump control switch to "
again, and water will fl ow out.
6.
After water does not drop out any more, you can pour the water in container
out then clean them thoroughly. Now you can start coffee brewing.
Note: There may be noise when pumping the water for the fi rst time, it is
normal, the appliance is releasing the air inside. After about 20s, the noise
will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating
the appliance before making coffee, including the funnel, fi lter and cup, so that
the coffee fl avour cannot be infl uenced by the cold parts.
1.
Remove the detachable tank and open the tank cover to fi ll it with desired
water. Τhe water level should not exceed the "MAX" mark in the tank.
Then place the tank into the appliance properly.
2.
Select the two cup mesh, set steel mesh into metal funnel. Make sure that
" position, the pump will pump
", press the coffee/steam selector to the
7
ENGLISH
" one time, the red
" position

Advertisement

Table of Contents
loading

Table of Contents